Cement, rust and building contaminant remover HMK R169 (concentrate), Möeller Chemie

Product code HMK R69-1.0 Categories ,

Price:

0.00

It is a concentrated, special, mild-smelling, acid-based cleaner for removing limescale deposits, rust stains, cement and mortar residues and post-construction dirt from all acid-resistant natural stone surfaces. Specially formulated for cleaning polished and hard stones. Thanks to the rust inhibitors contained in the product, it is very suitable for cleaning surfaces prone to rust.

It also removes residues from polishing and sanding.

Suitable for indoor and outdoor use.

Additional information

Purpose

Capacity

Manufacturer

Do you have questions about the product?

Fill out the contact form below and we will contact you!

    Use: To protect nearby surfaces from possible spills. Switch off floor heating. Dilute the product with water (1:2 to 1:10, depending on the level of contamination) and apply it to a cooled and thoroughly wetted surface using a mop, broom, brush or any other tool suitable for this purpose. Wait a few minutes (without allowing to dry), re-treat and remove any residual dirt. The surface shall then be thoroughly cleaned with R155 cleaner diluted approximately 1:20 with water. The cleaned surface shall be thoroughly rinsed with water. In case of very heavy contamination, the cleaning process shall be repeated.

    To avoid defects in the chemical treatment and to determine the required cleaning time, it is recommended to test the effect of the product on a redundant piece of the same stone or on the invisible side of the product. The treatment temperature shall be between +12 and +25 °C.

    Important: Avoid direct sunlight during processing. Acid-sensitive surfaces, polished or honed marble, terrazzo, metals, plastics may be damaged during cleaning.

    Consumption: approx. 10-60m2/litre.

    Store in a cool dry place, tightly closed. Shelf life several years.

    Use: To protect nearby surfaces from possible spills. Switch off floor heating. Dilute the product with water (1:2 to 1:10, depending on the level of contamination) and apply it to a cooled and thoroughly wetted surface using a mop, broom, brush or any other tool suitable for this purpose. Wait a few minutes (without allowing to dry), re-treat and remove any residual dirt. The surface shall then be thoroughly cleaned with R155 cleaner diluted approximately 1:20 with water. The cleaned surface shall be thoroughly rinsed with water. In case of very heavy contamination, the cleaning process shall be repeated. To avoid defects in the chemical treatment and to determine the required cleaning time, it is recommended to test the effect of the product on a redundant piece of the same stone or on the invisible side of the product. The treatment temperature shall be between +12 and +25 °C. Important: Avoid direct sunlight during processing. Acid-sensitive surfaces, polished or honed marble, terrazzo, metals, plastics may be damaged during cleaning. Consumption: approx. 10-60m2/litre. Store in a cool dry place, tightly closed. Shelf life several years.

    Recently viewed